Page 1 of 1

length of nose measurment

Posted: Mon Jun 13, 2016 7:15 am
by aseedylot
I have an existing bullet that I am taking measurements from for a mold. When i am measuring the nose length of bullet is the length to the top or bottom of the crimp grove? Thanks again for your help. I have two molds from you already and could not be happier.

Re: length of nose measurment

Posted: Mon Jun 13, 2016 7:56 am
by mtngun
I'm glad you like your molds.

This should answer your question about the program's "nose length." It's basically how much you want to stick out of the case.
Image