- Site Admin
- Posts: 1633
- Joined: Fri Feb 01, 2008 5:45 pm
- Location: Where the Salmon joins the Snake
Lyman/RCBS dies made to custom ID's. The ejector pin is relieved and vented. Largest practical ID is about .517". Smallest is .257". Die tolerance is nominal to +0.0003". A proof slug of WW alloy sent with the die. ID's required for very hard or very soft alloys require you provide 3 slugs for proofing the die.
Lee type push through dies with pushrod. Turned for the Lee catcher cup, no lockring provided. Same criteria as above.
Lyman/RCBS dies $24 ea + $2.50 rtn shp via USPS 1st class. Lee dies $19 per and same shipping as above. Personal checks firstname.lastname@example.org
501 Lime St
The above are the only dies I make. I don't polish out factory dies. In case there is interest I also make custom epoxy fill nose punches for Lyman-RCBS and Saeco presses.
- Posts: 2
- Joined: Sun Feb 10, 2008 1:54 pm
I see that you are branching out - About time.
Just in case anyone wants to know - Rick (AKA Buckshot) makes outstanding sizer dies.
Return to “General”
Who is online
Users browsing this forum: No registered users and 3 guests