need mold modification
need mold modification
I had you build me a mould for my 358. it is 250 grain with a real big meplat. well it wont feed in my model 600 remington but shoots great and casts great. If it had a smaller meplat it should feed just fine. It would of course be heavier. do you do any modifications after the mould has been made or no.
-
mtngun
- Site Admin
- Posts: 1640
- Joined: Fri Feb 01, 2008 5:45 pm
- Location: Where the Salmon joins the Snake
Re: need mold modification
Sorry to hear about the feed problem.
It is not cost effective to modify molds, and in any event, there is no way to cut a smaller meplat. You can only remove metal from the cavity, you can't put it back.
Dunno much about M600s, but the M700s will feed most anything after tuning (mostly tweaking the magazine so that the cartridge pops up pointed toward the chamber). Out of the box, they don't feed much of anything except spitzers or round nose.
It is not cost effective to modify molds, and in any event, there is no way to cut a smaller meplat. You can only remove metal from the cavity, you can't put it back.
Dunno much about M600s, but the M700s will feed most anything after tuning (mostly tweaking the magazine so that the cartridge pops up pointed toward the chamber). Out of the box, they don't feed much of anything except spitzers or round nose.
Who is online
Users browsing this forum: No registered users and 4 guests