online bullet design

jethunter
Posts: 1
Joined: Sun Jun 10, 2012 12:31 pm

online bullet design

Postby jethunter » Sun Jun 10, 2012 12:37 pm

Hi
I was trying to use the online bullet design program to design a bullet with .403" diameter, but the drop down menyu to select diamter does not go below .442". I know it used to allow smaller diameters because I previously used it to draw a .330" mtn mould that I bought within the last 1-2 years. Is the minimum OD now set at .442" for this program or am I doing something wrong so I can't get the drop down menu to go smaller than .442" bullet OD?

User avatar
mtngun
Site Admin
Posts: 1633
Joined: Fri Feb 01, 2008 5:45 pm
Location: Where the Salmon joins the Snake

Re: online bullet design

Postby mtngun » Sun Jun 10, 2012 2:05 pm

Sounds like you are stuck in the 45 caliber page.

Go to www.mountainmolds.com, click on the "online bullet design" button, and select 40 caliber. That should take you to the 40 caliber page.

Do not click the "GO" button or else you will end up on the 45 caliber page. The "GO" button is normally never used, but for some reason that I have since forgot, it was necessary to create the "GO" button, or else the code did not work right.

Thanks for asking the question. :)


Return to “General”

Who is online

Users browsing this forum: No registered users and 4 guests

cron